Rear Handle - Tools and Parts
-
V14 Handle Upgrade
-
V14 Handle Installation Pack
-
Size 4 allen key
Step 1 - remove the stock handle
Step 2 - slide the handle in place, make sure that the flat tabs on the plastic covers go underneath the slots of the handle
Step 3 - push the plastic covers back in place, check if they align with the handle. Mount the handle using provided screws.
If you want to install the seat upgrade, go to step 4.
If not, mount the plastic cover using stock screws.
Seat Upgrade - Tools and Parts
-
-
V14 Seat Base
-
V14 Seat
-
V14 Seat Installation Pack
-
Allen key – size 4
-
2 allen keys – size 2,5 (TX10 screwdriver can be optionally used instead of one of them)
-
Flat screwdriver (optional)
-
Step 4 - insert square M4 nuts into the slots on the bottom of the handle - you can use provided M4 bolts in this step as in the picture
Step 5 - mount the seat base using M5x25 and M4x35 screws
Make sure that the M4 screws went through the nuts, don’t overtighten the screws.
Step 6 - put the nuts inside the hinge elements of the seat as in the picture. Then put the seat on the base and push the nuts into the holes of the base - you can use flat screwdriver in this step.
Step 7 - put the M4x12 screw from the other side and tighten them together with nuts. You can use 2 allen keys or 1 allen and 1 torx.
Step 8 - stick the provided piece of soft velcro on the handle
