Veteran Patton S - kit assembly manual
Bottom Protection
Step 1 - rest your EUC on the kickstand to expose the bottom part. Start the installation with the bottom cover (PS BB C).
Make sure to push the tabs (marked with arrows) all the way into the slots on the bottom of your EUC. Repeat on the other side.
Step 2A - follow if you keep the stock JP mount. If you ordered set for the JP mount removal, go to step 2B.
Remove the 2 screws holding the bottom of the JP mount. Install the bumper (D1 - left, D2 - right) and secure it using M5x25 screws and washers provided with in the installation pack. Repeat the process on the other side.
Step 2B - follow this step for the set with JP mount removal.
Remove the whole JP mount from your EUC (4 screws on each side). Install the bumper and secure it using stock screws.
Repeat the process on the other side.
Step 3 - now rest your EUC on the front handle to expose the kickstand. Remove the screws holding the bottom part of the kickstand. Install the rear bumper (D1 - right, D2 - left) and secure it using M5x25 screws and washers provided with in the installation pack. Repeat the process on the other side.
Rear Handle
Step 1 - remove the stock handle on one side (3 screws).
Step 2 - install the rear bumper on your EUC. Make sure that the flat tab and zipties wrap around the oval profile. When the element is properly positioned, secure it with stock screws and tighten the ziptes. When inserting the screws, start with the silver ones first and finish with the black screw holding the handle. Repeat the process on the other side.
Seat
Step 1 - if you use the seat with stock handle, insert the pins into the slots as in the photo below. Their purpose is to lock with the stock handle when the seat is opened. Don't use them with our accesory rear bumper.
Step 2 - install the seat on the rear handle. On the bottom part there is a piece of velcro with white protective paper. Align the strip with the opposite part and peel the protective paper of. Close the seat and push it firmly to the body of the EUC. Now open it and the strip of velcro should stay on the EUC body.
