Sherman S – Bumpers & Seat Combo: Installation Guide

Step I – Preparation

  1. Clean the body of your EUC of sand, dust or any contaminations.

  2. Degrease the corners of the EUC body where tape will be applied. Do not use glycerine containing sanitisers. 
    Rubbing (isopropyl) alcohol is best for this purpose.

Step II – Front Handle & Bumpers

  1. Start with the handle cover, insert M5 nuts in the slots.



  2. Mount the cover on the handle,
    then lift the trolley handle lock so the cover can fully wrap the handle.



  3. Secure the cover using 2 M5x20
    screws from the installation pack. Tighten the screw untill the gap on the back
    of the handle is closed. Do not overtighten the screws!!!



  4. Remove the screw holding the
    front lamp on the right side and insert the plastic sleeve. If you remove both
    screws, the lamp will fall out, making the installation more difficult.



  5. Find the bumpers with screw holes and markings FT LEFT and RIGHT, check the fitting before sticking it to the EUC body. Pick the RIGHT bumper and when you are sure that everything fits correctly, peel the red foil from tape and mount it on the euc body. Left bumper will be installed after the one on right side is secured with a screw.



  6. Secure the bumper with M5x55 screw from the installation pack.



  7. Repeat the proces on the left side.

  8. Press the bumpers on both sides to the euc body so the tape can fix with the surface. Apply pressure for at least 30s.

Step III – Rear Handle & Bumpers

  1. Start with the handle cover, insert M5 nuts in the slots.

  2. Mount the cover on the handle and secure using M5x18 screws from the installation pack. Tighten the screw untill the gap on the back of the handle is close. Do not overtighten the screws!!!

  3. Remove the screw holding the rear lamp on the right side and insert the plastic sleeve.

  4. Find the bumpers with screw holes and markings RT LEFT and RIGHT, check the fitting before sticking it to the EUC body. Pick the RIGHT bumper and when you are sure that everything fits correctly, peel the red foil from tape and mount it on the euc body. Left bumper will be installed after the one on right side is secured with a screw.
  5. Secure the bumper with M5x50 screw from the installation pack.

  6. Repeat the proces on the left side.
  7. Press the bumpers on both sides to the euc body so the tape can fix with the surface. Apply pressure for at least 30s.

IV – Bottom Bumpers

  1.  Bottom bumpers are mounted on the EUC using provided velcro pads. On each of the bumpers there is a piece of velcro which has to be applied on the EUC body.  There are markings on the inside of bumpers for easier fitment (FR – front right, FL – front left, RR – rear right, RL – rear left).

V – Seat & Top Fairings

  1. Top suspension covers are mounted without any additional screws. You will find „L” and „R” marks on the inner flat surfaces of the parts. Slide the on top of the brass suspension screws and push untill they reach the surface of the EUC body.
  2. Seat is also mounted without any additional elements. Align the seat with trolley handle and wrap the brackets on the sides.
Shopping Cart