Contents:
1. Bumpers and Fairing Plates
2. Taillights
1. Bumpers and Fairing Plates
Step 1 - In this step you need parts 1L/R, and 4 front bumpers. Bumpers are marked as FBB L/R and FTB L/R. FBB are bottom and FTB are top bumpers.
Insert the part 1 into the slots of your EUC
Step 2 - Install the front bumpers, FBB on the bottom and FTB on the top.
There is a tab on the inside of the bumpers that needs to wrap around the edge
of the EUC shell.
Step 3 - Repeat the process on the other side of the EUC.
Step 4 - In this step you need the fairing plates, parts 4L/R and the screw pack.
Put the EUC on the front stand, remove the screws holding the kickstand and the corner of the shell.
Step 5 - Remove the small piece of velcro attached to the fairing plate.
Apply it on the kickstand of the EUC.
Step 6 - Align part 4 with the fairing plate and lock it together using the M5x50 screw.
Step 7 - Put the plate on the EUC, insert the screw into the kickstand thread and screw it in partially, don't tighten yet. Align the plate with the hole in the corner and secure it with the M5x30 screw. Now tighten both the kickstand and corner screw.
Step 8 - Repeat the process on the other side
Step 9 - In this step you are going to need the front inserts and remaining screws.
Put your EUC on the kickstand and find the right inserts. They only fit in one position, so please see the pictures below.
Step 10 - Secure the front of the plates using the remaining screws and inserts
on both sides.
--------------------------------------------------------------------------------------------------------
2. Taillights
Step 1 - Put your EUC on the front stand. Remove the rubber cover and the screws holding the rear of the fairing plate to get a better access.
Step 2 - Unbox the taillights, in the package you will find left and right light and the mounting screws. Please note that the lights are marked for the left and right side. Make sure that you install them correctly.
Step 3 - Guide the cable through the space above the top rib - marked in the picture below. The mini-jack connector must be positioned like in the picture and then pushed inside.
Step 4 - Attach the light to the plate using M4x12 screws and washers.
Reinstall the screws holding the rear of the fairing plate and connect
the mini-jack to the EUC.
Step 5 - Repeat the process on the other side.
