Installation
Step 1: Disassemble stock pedal from one side of your EUC. First you need too loosen the middle screw on the bottom of L-bracket. Then remove the screws holding the axis on both ends of the pedal. Push the axis from one side with allen key to remove it.
Step 2: Remove the axis from the Grizzla pedal you want to install. First pull out the black cap from the screw on one side, remove the screw and slide out the axis.
Step 3: Mount the pedal on the L-bracket, insert the screw holding the axis, tighten it and secure with the black cap. Tighten the middle screw on the bottom of L-bracket.
Pedal Angle Adjustment
Step 1: Loosen the screws holding the steel plate and remove the rubber plug on the side of the pedal. You can access the adjustment screws through the hole using 4mm allen key.
Step 2: Unfold the pedal and turn one of the screws untill you reach desired angle. While the pedal is unfolded, tighten the screws holding the steel plate. Lastly, screw in the second adjustment screw untill you feel that it reached the steel plate.
Step 3: Make sure that both adjustment screws are at the same depth inside the pedal. You can do it using an allen key with depth marked using a piece of tape. You can use it during the installation of the second pedal to obtain a symmetric angle on both sides. When the adjustment is done, secure the hole with the rubber insert. Repeat the process on the other side.
